联系人:李进
邮箱:lijin810230@163.com
电话:13798234453
地址: 中国 广东 深圳市福田区中航路世纪汇都会轩3305
| 品牌 |
Digilent |
品牌 |
Inc. |
| 型号 |
410-249 |
货号 |
410-249 |
| 材质 |
烧录器 |
|
410-249 JTAGHS2 FPGA PROGRAMMING CABLE
The Joint Test Action Group (JTAG)-HS2 programming cable is a high-speed programming solution for Xilinx fieldprogrammable gate arrays (FPGAs). The cable is fully patible will all Xilinx tools and can be seamlessly driven from iMPACT, Chipscope?, and EDK. The HS2 attaches to target boards using Digilent's 6-pin, 100-mil spaced programming header or Xilinx's 2×7, 2mm connector and the included adaptor.
The PC powers the JTAG-HS2 through the USB port and will recognize it as a Digilent programming cable when connected to a PC, even if the cable is not attached to the target board. The HS2 has a separate Vdd pin to supply the JTAG signal buffers. The high speed 24mA three-state buffers allow target boards to drive the HS2 with signal voltages from 1.8V to 5V and bus speeds of up to 30MBit/sec. To function correctly, the HS2's Vdd pin must be tied to the same voltage supply that drives the JTAG port on the FPGA (see Fig. 1).
The JTAG bus can be shared with other devices as systems hold JTAG signals at high-impedance except when actively driven during programming. The HS2 es with a standard Type-A to Micro-USB cable that attaches to the end of the module opposite the system board connector. The system board connectorshould hold the small and light HS2 firmly in place (see Fig. 2)
Features include:
? Small, plete, all-in-one JTAG programming solution for Xilinx FPGAs
? Compatible with all Xilinx tools
? Compatible with IEEE 1149.7-2009 Class T0 - Class T4 (includes 2-Wire JTAG)
? Separate Vref drives JTAG/SPI signal voltages; Vref can be any voltage between 1.8V and 5V.
? High-Speed USB2 port that can drive JTAG/SPI bus at up to 30Mbit/sec
? JTAG/SPI frequency settable by user
? Uses micro-AB USB2 connector
? SPI programming solution (modes 0 and 2 up to 30Mbit/sec, modes 1 and 3 up to 2Mbit/sec)
? Fully supported by the Adept SDK, allowing custom JTAG/SPI applications to be created
李 进
深圳博瑞图电子科技有限公司
MOB :
FAX :
ADD :深圳市福田区福明路中航路世纪汇都会轩3713
EMAIL :lijin810230@163.COM
网址: