原装 VNC2 DEBUG MODULE 调试器编程器模块 Vinculum II

1 Introduction

　　The VNC2 debug module consists of a miniature board with a USB miniB connector, which provides USB connectivity to Vinculum-II IDE development tools running on a PC. The VNC2 debug module can be used to program and debug firmware running on the VNC2 device.

　　The module connects to the VNC2 device via a 6-way, 2mm pitch, keyed, female connector. The V2DIPxx, VNC2 based development modules are equipped with a patible male connector to host the VNC2 debug module. Designers intending to use the module with their own VNC2 based hardware are required to have a similar patible male connector on their hardware. Details on the debug interface and connectors are outlined in subsequent sections of this document.

2. Features

　　The VNC2 debug module incorporates the following features:

　　.One USB ‘miniB’ type socket to connect with a

　　PC.

　　.Onboard F FT232R which provides conversion from USB to serial interface for

　　VNC2 debug port.

　　.Low USB bandwidth consumption.

　　.USB2.0 Full Speed patible.

　　.UHCI/OHCI/EHCI host controller patible. 5V Power output to V2DIP-x module (if

　　needed).

　　.USB powered.

　　.Programming and debugging for VNC2 IC designs.

　　.Power and traffic indicator LEDs

　　.6 way, keyed connector to support F’s range of V2DIPx-x development modules.

　　.VNC2 debug module is a Pb-free, RoHS plaint development module.

　　.-40℃ to +85℃ operating temperature range.

　　李 进

　　深圳博瑞图电子科技有限公司

　　TEL :

　　MOB :

　　FAX :

　　ADD :深圳市福田区中航路都会轩1416

　　EMAIL :lijin810230@163.COM

　　网 址：