艺佰涂异丁基三乙氧基硅烷浸渍液

艺佰涂异丁基三乙氧基硅烷浸渍液

价格 100.00
起订量 10㎡
货源所属商家已经过真实性核验
品牌 其他
型号 YBT-21
关键字
在线咨询 立即下单 留言询价 电话咨询
广东众建新型材料有限公司
通过真实性核验手机验证
主营:
PB-2聚合物改性沥青防水涂料

进入店铺全部产品

店内推荐

联系我们

联系人:蔡先生

邮箱:1348503109@qq.com

电话:17666668815

地址: 广东广州市白云区广州白云区太和工业园区

产品详情
品牌

其他

型号

YBT-21

类型

高分子防水涂料

液态类型

水乳型

成膜物性质

有机

施工方法

储存期

12个月

固体含量

98%

每公斤涂刷面积(两遍)

1m2

耐洗擦性

耐水性

不透水

稀释剂

水溶性

拉伸强度

2Mpa

断裂伸长率

800%

表干时间

1小时

干燥时间

3小时

漆膜颜色

未知

适用范围

桥面防水。隧道防水

包装规格

50kg

  艺佰涂异丁基三乙氧基硅烷浸渍液

  ◆ 产品说明

  本品为高纯度异丁基三乙氧基硅烷,可渗透到混凝土内部与暴露到酸、碱性环境中的空气及水分子发生反应,形成斥水层,产生防水、防cl、抗紫外线的性能。可有效防止日照、酸碱、海水、盐雾对混凝土的侵蚀,从而保护混凝土内部钢筋结构不被腐蚀。该产品主要用于高速公路桥梁结构、港口码头、海工、立交桥、电线杆、污水处理池、温差极大的高原地区等,是国家混凝土防腐蚀规范推荐产品。

  ◆ 产品标准

  纯度 99%

  颜色 无色透明

  密度 0.88g/cm3

  ph值 5-6

  ◆ 使用方法

  ⊙ 使用前应清洁基材表面,无积水、污物、灰尘、油渍等污染物;

  ⊙ 可使用喷枪、滚筒、刷子等工具进行施工。应反复喷刷,保持表面10分钟以上湿润,直止彻底渗透为止。

  ⊙ 应使表面尽量干燥,以达到浸渍效果。

  ◆ 注意事项

  ⊙ 本品为易燃品,应注意安全预防措施,远离火源,严禁撞击,不要暴晒,注意通风。

  ⊙ 严禁与水混合。

  ⊙ 4℃以下40℃以上不得应用。

  ⊙ 浸渍时应保持清洁,不能溅到其它物体、植物等。

  ⊙ 施工人员要求穿戴护目镜和防护手套。如接触到皮肤和眼睛,立即用清水清洗。

  ◆ 包 装

  20-180㎏/桶,在0-30℃环境中保质期一年。

  ◆ 本产品适用规范要求

  ⊙ 公路工程混凝土结构防腐蚀技术规范jtg/t b07-01-2006

  ⊙ 海港工程混凝土结构防腐蚀技术规范 jtj/275-2000

  isobutyl triethoxy silane impregnating solution

  product deion

  this product is a high purity isobutyl triethoxysilane, which can penetrate into concrete and react with air and water molecules exposed to acid and alkaline environment to form a water repellent layer, producing water-proof, cl-proof and ultraviolet-resistant properties. it can effectively prevent the erosion of concrete by sunshine, acid and alkali, sea water and salt spray, thus protecting the reinforced structure inside concrete from corrosion. this product is mainly used in highway bridge structure, port wharf, marine engineering, overpass, pole, sewage treatment tank, plateau area with great temperature difference, etc. it is recommended by the national concrete anti-corrosion code.

  product standard

  purity 99%

  colorless and transparent

  density 0.88g/cm3

  ph 5-6

  use method

  before cleaning, the substrate should be cleaned without contaminants such as water, dirt, dust and oil stains.

  it can be constructed by means of spray guns, rollers, brushes and other tools. it should be repeatedly sprayed to keep the surface moist for more than 10 minutes until completely penetrated.

  the surface should be as dry as possible so as to achieve the best soaking effect.

  note

  this product is inflammable, we should pay attention to safety precautions, keep away from fire sources, strictly prohibit impact, do not expose to the sun, pay attention to ventilation.

  it is forbidden to mix with water.

  it should not be applied if the temperature is below 40 c below 4 c.

  it should be kept clean when impregnated, and should not splash onto other objects or plants.

  the construction personnel are required to wear goggles and protective gloves. if contact with skin and eyes, wash with water immediately.

  packing

  20-180 centimetre / barrel, the shelf life is 0-30 years.

  this product is applicable to specification requirements.

  technical specification for corrosion prevention of concrete structures in highway engineering jtg/t b07-01-2006

  technical specification for anticorrosion of concrete structures in hai harbour engineering jtj/275-2000

商家电话:
17666668815