怎么给玻化砖翻新除污

　　1、用翻新机或晶面机（是有调速的），按磨片的顺序1#—4#（玻化砖专用）研磨至国家标准光泽度（55度以上）。如用调速机研磨1#.2#磨片.磨削转速调至175转/分，3#4#磨片，磨削转速调至300转/分。

　　2、Use the refurbished machine or the planer (preferably with a speed adjustment) and grind to the national standard gloss (over 55 degrees) in the order of 1 # - 4 # (vitrified brick). Use the speed adjusting machine to grind 1 #. 2 # grinding. Grinding speed to 175 RPM, 3 # 4 # grinding, grinding speed to 300 RPM.

　　2、因使用陈旧需翻新的砖面，用特制的金属磨轮0#对地面进行磨削，（机械速度不要过快，175转/分即可）。然后用专用磨片按序施工。发现空鼓或未粘接现象，要及时处理，避免较重的研磨机械压损砖体或无法整平，从而影响整体施工效果。

　　3、打磨完成后，为提高玻化砖的抗污力和耐磨度，必须对其进行防污处理，前面介绍的防污处理、晶面处理、水晶处理等均可达到理想的效果；但需注意的是：未处理的空鼓部位，必须将其周围或底部水分吸净，否则析出的水分将影响下道工序无法完成；防污处理施用专用防污剂；晶面处理要求打磨时间足够；对品质较差的玻化砖施做水晶盾进行水晶处理时，要确保工序到位；这样，方可使得翻新后的玻化砖达到持久的晶面光泽和长期的加硬抗污能力。

　　3, after completion of polishing, in order to improve bo changes a brick of fouling resistance and wear resistance, must be anti-fouling processing, the introduced anti-fouling processing, crystal face treatment, crystal, etc all can achieve the ideal effect; However, it is important to note that the unprocessed air drum parts must be absorbed by the water around or at the bottom of the drum, otherwise the water from the water will not be completed in the next process. Anti-fouling treatment is best applied to special antifouling agents; The polishing time is sufficient. When crystal shield is used to make crystal shield for the inferior glass tile, make sure the process is in place. In this way, the refurbished glass brick can achieve a lasting surface gloss and long-term hard and anti-fouling ability.