热熔胶 TECHNOMELT PA 6832 BLACK

　　apple专用胶 technomelt pa 6818

　　product deion

　　technomelt pa 6818 provides the following product characteristics:

　　technology : polyamide

　　product type : hotmelt

　　cure : physical setting

　　condition : thermoplastic

　　components : one component

　　application : general assembly

　　appearance : amber

　　application areas:

　　technomelt pa 6818 is used for molding application. it has

　　high softening point and suitable for porous substrates such as

　　paper, wood and leather.

　　polyamide adhesive - nourde adhesives

　　softening point : 206~216℃

　　melting viscosity at 235℃, mpas : 4000~7500

　　elongation, % : 300

　　application:

　　application temperature: 225 to 240℃

　　application system: hotmelt application systems

　　when bonding to a substrate with high thermal conductivity the use of a specific application temperature is required for good wetting.

　　do not heat the product above the specified application

　　temperature range.

　　when the product is not in use do not apply heat, this will degrade the quality of the product and in extreme cases cause carbonisation. the standby temperature for the product is approximately 50℃ below the application temperature, but not for longer than 72 hours.

　　technomelt pa 6818 may absorb moisture from the air. this will not be apparent in the solid form, but may cause bubbles on heating and could affect the bond quality. it is important, therefore, that containers are kept closed and sealed when not in use.

　　cleaning:

　　carbonised and set (non thermoplastic) material must be

　　removed mechanically. removal of the thermoplastic material

　　from the hot apparatus can be achieved with solvent free

　　cleaning system.

　　classification:

　　please refer to the corresponding safety data sheets for details

　　on:

　　hazardous information

　　transport regulations

　　safety regulations

　　storage:

　　when properly stored in a cool, dry location, with the container

　　tightly closed when not in use, this product will have a shelf life

　　of at least 24 months.

　　nourde low pressure molding material solutions

　　additional information

　　disclaimer:

　　the information provided herein, especially recommendations

　　for the usage and the application of our products, is based

　　upon our knowledge and experience. due to different materials

　　used as well as to varying working conditions beyond our

　　control we strictly recommend to carry out intensive trials to

　　test the suitability of our products with regard to the required

　　processes and applications. we do not accept any liability with

　　regard to the above information or with regard to any verbal

　　recommendation, except for cases where we are liable of

　　gross negligence or false intention.

　　this datasheet replaces all former versions.

　　reference 0.0

　　technomelt pa 6818