供应新品腋拐载荷耐久试验机 价格优惠

　　iso24415腋拐载荷耐久试验机，具体技术参数来电咨询

　　a)Fix the tip sample to the loading rod. During the test the tip sample shall not be turned.b)Position the loading rod so that the tip just touches the test track at a tilt angle of -20°℃.c)Load the tip to (100±20)N.

　　(A)将样品固定在加载棒上。(B)放置加载杆，使加载杆在-20°℃.C的倾斜角下接触到试验轨迹，加载到(100±20)N。

　　d) Start to activate smoothly both the loading force mechanism and the motion control mechanism.

　　开始平稳地启动加载力机构和运动控制机构。

　　e) Exert the loading force smoothly to the maximum axial load of (5oo+20')N when the loading rod is

　　E)当加载杆为(5oo+20‘)N时，将加载力平滑地施加到(5oo+20’)N的轴向载荷

　　perpendicular to the test surface.

　　垂直于测试表面。

　　f)Release the loading force smoothly to 0 N as the rod is tilted to a tilt angle of +20°℃.

　　(F)当杆倾斜到+20°℃时，将加载力平稳地释放到0 N。

　　g)Lift the tip up from the test track and return the loading rod to the start position, as described in b).h)Repeat the procedure from b) to g) 500 000 times with a frequency less than 0,8 Hz.

　　(G)如b).h所述，从测试轨道上抬起顶部，并将加载杆返回起始位置，从b)重复到g)500 000次，频率小于0、8 Hz。

　　i)After 500 000 cycles, check the tip as described in Clause 4.

　　(I)在500 000个周期后，检查第4条所述的小费。

　　j)Three samples shall be tested and the results recorded.

　　(J)对三个样品进行测试并记录结果。