进口双阀座蒸汽疏水阀 大排量杠杆浮球式疏水器 美国RETZ瑞茨

　　品牌：RETZ瑞茨/我们一直致力于流体控制和测控领域的持续创新，始于2005……

　　(大排量)双阀座蒸汽疏水阀适用于大型蒸汽设备，压力波动较大或容易产生大量凝结水的场合，如各种蒸汽管网、加热设备、烘干设备、伴热设备、石油化工蒸馏塔设备等retz (Large displacement) imported doubleseat steam trap valve is suitable for large steam equipment, occasions withlarge pressure fluctuations or prone to producing a large amount of condensate,such as various steam pipe networks, heating equipment, drying equipment, heattracing equipment, petrochemical distillation tower equipment, etc

　　进口双阀座蒸汽疏水阀主要性能 Main performance

　　双阀座大排量蒸汽疏水阀在冷凝水轻或重的负荷下工作都十分有效率，它们的排水量持续且高效，保证大的热传递。此类阀门是带自动温度控制排水装置的好选择 RETZ Double seat largedisplacement steam traps work very efficiently under light or heavy load ofcondensed water. Their drainage capacity is continuous and efficient, ensuringmaximum heat transfer. This type of valve is the best choice with automatictemperature control drainage device.

　　设计标准:ISO6552；EN26704 Design standard: iso6552; EN26704

　　连接长度∶EN26554；GB/T12250 Connection length: EN26554;GB/T12250

　　试验与检验∶EN26948；GB/T12251 Test and inspection: en26948;GB/T12251

　　规格尺寸：1-1/4-6"(法兰) Specification and size: 1-1/4-6"(flange, internal thread RC, NPT)

　　排量：5000kg/h~30000kg/h 排量?5000kg/h~30000kg/h

　　进口双阀座蒸汽疏水阀特点∶ Performance characteristics

　　平衡双阀座设计，与同类的疏水阀相比体积小排量大，在需要大排量排除凝结水的工况，更能充分显示其优越的性能 RETZThe 进口双阀座大排量蒸汽疏水阀3.jpgbalanced double valve seat design, compared withsimilar drain valves, is small in volume and large in displacement, and canfully display its superior performance under the condition that largedisplacement is required to discharge condensate

　　阀体内设防冲蚀挡板，耐水锤震动 Anti erosion baffle is set in the valve body to resistwater hammer vibration

　　背压率大于90%，便于凝结水回收 The back pressure rate is greater than 90%,which is convenient for condensate recovery

　　内置自动排空气装置，启动迅速，无空气气堵，排除不可凝结气体性能好，可在线更换 Built in automatic air exhaust device,quick start, no air blockage, good performance of removing non condensable gas,and online replacement

　　排水阀座孔始终在凝结水水位以下，形成水封，工作时无新鲜蒸汽泄漏 The drain valve seat hole is always belowthe condensate water level, forming a water seal, and there is no fresh steamleakage during operation

　　进口双阀座蒸汽疏水阀选型参数

　　公称压力：16-40Bar Nominal pressure: 16-40bar

　　使用压差范围:0.1-32Bar Operating pressure difference range:0.1-32bar

　　介质温度：≤300℃ Medium temperature: ≤ 300 ℃

　　1、阀体 GGG40/A216 WCB/A351CF8

　　2、阀盖GGG40/A216WCB/A351CF8

　　3、阀盖垫片A240 304+石墨

　　4、阀盖螺栓A193 B7

　　5、浮球A240 304

　　6、浮球连杆结构ASTM CF8

　　7、阀座结构主体ASTM CF8

　　8、上阀芯 A276 430

　　9、下阀芯 A276 430

　　10、副阀座ASTM CF8

　　11、双阀座连杆A240 304

　　12、阀座螺栓A193 B8

　　13、排空气装置组件 A、膜盒 A240 304 B、弹簧17-4PH C、膜盒支撑片A240 304 D、膜盒阀座 A276 430 E、膜盒固定罩A240 304

　　14、挡板 A240 304

　　按流向箭头所示安装，注意浮球臂处于水平位置以确保其能垂直升降 Please install as shown by the flow arrowon the valve body. Note that the float arm is in the horizontal position toensure that it can rise and fall vertically